E-flite Blade mSR BNF Manual de instrucciones descargar pdf (Pagina 10)

18 19

12X:

A. Make sure the flight battery is disconnected from the 5-in-1 unit and the

transmitter is turned off.

B. Move the sticks and switches on the transmitter to the desired failsafe positions

(low throttle and neutral control positions).

C. Plug the flight battery into the receiver/5-in-1 unit. After 5 seconds the LED on the

5-in1 unit will begin flashing.

D. Press the bind button on the back of the transmitter while turning the transmitter

on. The bind button on the back of the transmitter will flash. Release the button

after 2–3 seconds.

E. The LED on the receiver/5-in-1 unit will go solid and the system will connect after

several seconds.

F. If you entered bind mode correctly, you will see a solid LED approximately 5–10

seconds later on the receiver/5-in-1. You should now be bound to the transmitter,

and have full control and function.

Transmitter Control Identification

Note: Each time before you fly you should ALWAYS turn the transmitter on before

connecting the flight battery to the 5-in-1 unit. After each flight, be sure

that you always disconnect the flight battery from the 5-in-1 unit before

powering the transmitter off.

Note: The E-flite MLP4DSM transmitter is shown throughout the manual

for reference only.

Mode 2

Throttle Trim Buttons

Aileron Trim Buttons

Elevator Trim Buttons

Rudder Trim Buttons

Mode 1

Elevator Trim Buttons

Aileron Trim Buttons

Throttle Trim Buttons

Rudder Trim Buttons

Rudder/Throttle

Functions

Rudder/Elevator

Functions

Aileron/Elevator

Functions

Aileron/Throttle

Functions

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 25 26

Sin comentarios

E-flite Blade mSR BNF Manual de instrucciones Pagina 10