E-flite UMX Yak 54 180 BNF Manual de instrucciones descargar pdf (Pagina 10)

DX4e and DX5e Expo Activation and Deactivation

DX4e (Modes 1 and 2)

Activate and Deactivate Expo

1. Put the ACT switch in the down position

(ON) and the Rate switch in the down

position (LO).

2. Push and hold the trainer (bind) button

and move and hold the two sticks (as

shown here) for activation (A) or

deactivation (B), while powering on

the transmitter.

3. Release the trainer switch and the

control sticks only after a series of

tones sound (ascending tones for

activation, descending tones for

deactivation).

DX5e (Modes 1 and 2)

Activate and Deactivate Expo

1. Hold the aileron trim switch to the right for

activation (C) or to the left for deactivation

(D), while powering on the transmitter.

2. Release the aileron trim switch after a

series of tones sound, (ascending tones

for activation, descending tones for

deactivation).

If you plan to ﬂ y your aircraft with a DX4e or DX5e, activate Expo for the best feel. Disconnect the battery

from the aircraft before activating the Expo feature in your transmitter.

Once Expo is activated, it will remain activated for subsequent power cycles of the transmitter. Once Expo is

deactivated, it will remain deactivated until it is activated again.

C D

Post Flight Checklist



1. Disconnect the ﬂ ight battery from the ESC

(Required for safety and battery life).

2. Power OFF the transmitter.

3. Remove the ﬂ ight battery from the

aircraft.

4. Recharge the ﬂ ight battery.



5. Store the ﬂ ight battery apart from the

aircraft and monitor the battery charge.

6. Make note of the ﬂ ight conditions and

ﬂ ight plan results, planning for future

ﬂ ights.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 18 19

Comentarios a estos manuales

Sin comentarios

E-flite UMX Yak 54 180 BNF Manual de instrucciones Pagina 10

Comentarios a estos manuales

Relacionado con productos y manuales para Juguetes con control remoto E-flite UMX Yak 54 180 BNF