E-flite UMX Radian BNF Manual de instrucciones Pagina 11

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 18
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 10
11
EN
Troubleshooting Guide
Problem
Possible Cause Solution
Aircraft will
not respond to
throttle but re-
sponds to other
controls
Throttle stick and/or throttle trim is too
high
Reset controls with throttle stick and
throttle trim at lowest setting
Throttle channel is reversed Reverse throttle channel on transmitter
Motor is disconnected from receiver Open fuselage and ensure the plug for
the motor is properly installed
Extra propeller
noise or extra
vibration
Damaged propeller, prop shaft or motor Replace damaged parts
Nut on prop shaft is too loose Tighten the prop shaft nut 1/2 turn
Reduced fl ight
time or aircraft
underpowered
Flight battery charge is low Completely recharge fl ight battery
Propeller is installed backwards Install propeller with numbers facing
forward
Flight battery is damaged Replace fl ight battery and follow fl ight
battery instructions
Flight conditions may be too cold Make sure battery is warm before use
Battery capacity is too low for fl ight
conditions
Replace battery or use a larger capacity
battery
Problem
Possible Cause Solution
Control surfaces
not at neutral po-
sition when trans-
mitter controls are
at neutral
Control surfaces may not have been
mechanically centered from factory
Center control surfaces mechanically by
adjusting the U-bends on control link-
ages
Aircraft was moved after the fl ight
battery was connected and before
sensors initialized
Disconnect and reconnect the fl ight
battery while keeping the aircraft still for
5 seconds
Model fl ies in-
consistently from
ight to fl ight
Trims are moved too far from neutral
position
Neutralize trims and mechanically adjust
linkages to center control surfaces
Controls oscillate
in fl ight, (model
rapidly jumps or
moves)
Propeller is unbalanced, causing
excessive vibration
Remove propeller and rebalance or
replace it if damaged
Nut on prop shaft is too loose, caus-
ing excessive vibration
Tighten the prop shaft nut 1/2 turn
AS3X
Vista de pagina 10
1 2 ... 6 7 8 9 10 11 12 13 14 15 16 17 18

Comentarios a estos manuales

Sin comentarios