E-flite UMX Beast 3D BNF Manual de instrucciones descargar pdf (Pagina 11)

Troubleshooting Guide

Problem Possible Cause Solution

Aircraft will not

respond to throttle

but responds to other

controls

Throttle stick and/or throttle trim too high Reset controls with throttle stick and throttle

trim at lowest setting

Throttle channel is reversed Reverse throttle channel on transmitter

Motor disconnected from receiver Open fuselage and make sure motor is

connected to the receiver

Extra propeller noise

or extra vibration

Damaged propeller, spinner or motor Replace damaged parts

Prop screw is too loose Tighten the prop screw

Reduced ﬂ ight time

or aircraft underpow-

ered

Flight battery charge is low Completely recharge ﬂ ight battery

Propeller installed backwards Install propeller with numbers facing forward

Flight battery damaged Replace ﬂ ight battery and follow ﬂ ight battery

instructions

Flight conditions may be too cold Make sure battery is warm before use

Battery capacity too low for ﬂ ight conditions Replace battery or use a larger capacity battery

LED on receiver

ﬂ ashes and aircraft

will not bind to

transmitter (during

binding)

Transmitter too near aircraft during binding

process

Power off transmitter, move transmitter a larger

distance from aircraft, disconnect and reconn-

ect ﬂ ight battery to aircraft and follow binding

instructions

Bind switch or button not held long enough

during bind process

Power off transmitter and repeat bind process.

Hold transmitter bind button or switch until

receiver is bound

LED on receiver

ﬂ ashes rapidly and

aircraft will not

respond to transmit-

ter (after binding)

Less than a 5-second wait between ﬁ rst

powering on transmitter and connecting

ﬂ ight battery to aircraft

Leave transmitter on, disconnect and reconnect

ﬂ ight battery to aircraft

Aircraft bound to different model memory

(ModelMatch

radios only)

Select correct model memory on transmitter

and disconnect and reconnect ﬂ ight battery to

aircraft

Flight battery/transmitter battery charge is

too low

Replace/recharge batteries

Problem Possible Cause Solution

Control surfaces are

not at neutral position

when transmitter

controls are at neutral

Control surfaces may not have been

mechanically centered from factory

Center control surfaces mechanically by

adjusitng the U-bends on control linkages

Aircraft was moved after the ﬂ ight battery

was connected and before sensors

initialized

Disconnect ﬂ ight battery and reconnect while

being sure model does not move for 5 seconds

Model ﬂ ies incon-

sistently from ﬂ ight

to ﬂ ight

Trims are moved too far from neutral

position

Neutralize trims and mechanically adjust

linkages to center control surfaces

AS3X

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 17 18 19

Comentarios a estos manuales

Sin comentarios

E-flite UMX Beast 3D BNF Manual de instrucciones Pagina 11

Comentarios a estos manuales

Relacionado con productos y manuales para Juguetes con control remoto E-flite UMX Beast 3D BNF