E-flite Ultra Micro 4-Site BNF Manual de usuario

EFL9080© 2009 Horizon Hobby, Inc.4105 Fieldstone Road Champaign, IL 61822USAHorizon Hobby UK Units 1-4 Ployters Rd Staple Tye Harlow, Essex CM18 7NSUn

18 1918 19Control TestYou must test the controls prior to the rst ight to ensure none of the servos, linkages or parts were damaged during shipping

20 2120 21Move the rudder stick left and right to check yaw control. When the stick is pushed to the right the rudder should also move to the right.Wi

22 2322 23Dual Rates and ExpoE-flite recommends using a DSM2 radio capable of dual rates and expo. The settings below are recommended starting settings

24 2524 25proceed to the next step of the checklist.• If the status LED keeps ashing, you do not have a positive RF link between the transmitter and

26 2726 27Flying the Ultra-Micro 4-SiteHaving followed the proper receiver initialization and arming procedures, confirmed proper control of the servos

28 2928 29Replacement PartsItem DescriptionEFL9050 ... Ultra-Micro 4-Site PNP (replacement airframe with receiver and servos)EFL9051 ...

30 3130 31Troubleshooting GuideProblem Possible Cause SolutionAircraft will not “throttle up” but all other controls seem to function.• User did not

32 3332 33Law: These Terms are governed by Illinois law (without regard to conflict of law principals).Safety PrecautionsThis is a sophisticated hobby

34 3534 35United States Electronics and engines requiring inspection or repair should be shipped to the following address:Horizon Service Center 4105

36 3736 37CE Compliance Information for the European UnionInstructions for Disposal of WEEE by Users in the European UnionThis product must not be di

2 32 3IntroductionCongratulations on the purchase of your Ultra-Micro™ 4-Site™. Its amazing performance is the result of many E-flite advances, not the

38 3938 39

4 54 5Additional Safety Precautions and Warnings As the user of this product, you are solely responsible for operating in a manner that does not endan

6 76 7Preparing for the First Flight ChecklistRC airplanes are not toys. Please note this checklist is not intended to be a replacement for the conten

8 98 9Li-Po cells should not be discharged to below 3V each under load. In the case of the 1S Li-Po battery used for the 4-Site, you will not want to

10 1110 11Please follow these steps to charge your single-cell Li-Po battery with the Celectra 4-port Li-Po charger.FOR PORTABLE USE:• Remove the cove

12 1312 13Usage Guidelines, Warnings and Safety Precautions• Always inspect batteries before charging.• Never charge or use a Li-Po battery or pack th

14 1514 15Installing the Flight Battery1. Install the battery into the fuselage by first plugging the battery into the receiver. 2. Mount the battery i

16 1716 17Transmitter Specific Binding InstructionsDX6i:A. Select a new model memory or the chosen model memory that you want for the 4-Site.B. To bi